Hola muchachos ahora en la remodelacion de mi tanquesito quiero poner water colors como fondo pero la verdad que no entendi como se instala ,mire la explicacion en la pagina del Sr.Juan Jose pero tampoco entendi nada adly:adly: creo que ando medio burro jeje ,si alguien tiene experiencia en la colocacion de este por favor que me lo diga :bien:
Respuesta: Duda con water color. Hola: Al bote que viene con rociador, le pones 4 gotas de jabon liquido. Con ese, mojas el vidrio, y mojas el reverso del watercolors (al que ya le quitaste la pelíciula protectora). Le calculas que cubra toda el área, lo pones suavecito y lo vas "jalando" del centro hacia las esquinas, para que se vayan saliendo las burbujas de aire. Para ello te ayudas con la espatulita que viene en el kit. Alguna vez viste como se ponía el papel tapiz? Bueno, pues así mesmo.. Saludos Robado de una tienda marina: Directions: Prepare a Soap-Water Solution: Prepare a solution by adding 4 drops of dish soap to the provided 4oz. spray bottle. Normal liquid dish soap (containing no lotions, oils, waxes or enzymes) works fine. Prepare Work Area and Materials: Measure the area you wish to apply background to and cut the background to that measurement. Make sure the work surface, aquarium, and surrounding area are properly cleaned to avoid contaminating the background. Even if the aquarium appears clean, it should be cleaned with the spray soap-water solution (make sure aquarium surface is clean of all impurities). DO NOT ALLOW BACKGROUND BACKING TO GET WET. Applying Water Color Background: Use the spray soap-water solution to wet the aquarium surface you are applying background to. Make sure your work surface and surrounding areas are clean and free of contaminates. On a flat surface (like a table or countertop) place the background color side down, pull the backing off (keeping the backing parallel to the work surface). Wet the entire adhesive side using the spray soap-water solution. Carefully place the background (adhesive side) to the aquarium surface you are applying to. Lightly squeegee horizontally, working from the center outwards to the left and then to the right. Applying more pressure, continue working the remainder of air and solution out from between the aquarium and the background. Allow 90 minutes for adhesive to set before moving or touching applied background.